that's correct, but I only have one physical IDE slot on the MB, so that means I can only connect one thing at the same time.
I can't connect my flash drive as on an IDE cable since it's a female connector, unless I had a male to male IDE connector, but I don't at this moment, and all stores are closed on sunday.
so usb didn't worked… I opened my external laci hard drive to get out the IDE to USB controller and used that one to put the flash disk on, it worked perfectly.
I booted from the live CD, and installed it to my flash disk using command 99, placed the flash disk back on the MB and was able to get it booted, however after a while in the boot process I get the request to enter a manual root filesystem specification. <fstype>: <device>when I list the valid disk boot devices I get:
ad0s1c ad0s1b ad0s1a ad0s1 ad0
and teh command line says <mountroot>I'm new to this all so what should I do now? which volume do I need to boot and what flile system should I use.
tnx for any input :-)</mountroot></device></fstype>