Ticket 1033: DHCP Range set from console gets ignored
-
from the console, if i do 4 to reset back to defaults. Reboot, then set my DHCP range after i set my lan ip. The range that actually gets set is different. ex:
lan ip: 172.31.253.254 subnet: /24
dhcp? yes start ip: 172.31.253.20 stop ip: 172.31.253.106
what actually goes into the web interface is 172.31.253.10-245
I tested with 192.168.7.10 192.168.7.200
in web interface stop is 192.168.7.245
used console to define dhcp not web interface
-
Resetting to factory defaults triggers the config wizard which will recalculate the IP-Adress range for IP-Adresses/subnets different from 192.168.1.1/24. I guess that is what happens. Did you run the configwizard after you did the reset or did you bypass it by clicking the pfSense logo at the welcome screen?
-
I tried reproducing this issue from the console and it worked as it should.
-
Just install and set ip, i try do reset do default and tested again but has the same result!
-
Just tried it again, it set the range I told it to.