GW Problem: error socket: sendto error 55/error 64
-
Hi Team,
I use pfSense v2.3 release for my local network (about 350 users connected with 2 LAN and 3 WAN interfaces hosted in a vmware).
Since thursday, I have the below message in my pfSense Gateway's tab log:
dpinger GWNAME IP_ADDRESS: sendto error: 55
dpinger GWNAME IP_ADDRESS: sendto error: 64My bandwidth is limited on 4Mbps even if I have 15Mbps allowed from my ISP. I don't know why! (There are no bandwidth limitation in pfSense )
Did someone have the same issue?
Regards,
Andrès
-
I am having the exact same issue. I loose connectivity to the internet and I have these messages in my log files:
Apr 25 21:56:44 dpinger WANGW xxx.xxx.xxx.xxx: sendto error: 64
Apr 25 21:56:45 dpinger WANGW xxx.xxx.xxx.xxx: sendto error: 65 -
jyrandrianiaina: Which type of NICs are you using? If e1000/em, it's better to use vmxnet3. Not that e1000 should hurt anything, but switch to vmxnet3 if you're not on that already. That'll also give us a better idea of the source of the issue.
-
Hi cmb,
Thank for your answer, I will swith to vmxnet3 and will let you know later.
Regards,
-
Switching to vmxnet3, my internet connexion look like stable. There are no error in the gateway's tab log.
-
Apr 25 21:56:45 dpinger WANGW xxx.xxx.xxx.xxx: sendto error: 65
Same as the above appeared for me when upgrading from 2.3.1_? to most recent 2.3.1_p5 (stable).
-
hi, i try use e1000 and vmnetx3, and all cases the network system respond few minutes ok, the sequence is very slow. In /var/log/gateways i receive the error:pfsense dpinger: GW_LAN 1-.x.x.x: sendto error:50
-
This post is deleted!