Any / Any Rules not working?
-
I'm trying to get two devices on separate VLANs (configured in pfSense) to talk.
So I have a PC in VLAN 100 (10.0.100.60) trying to talk to a PC in VLAN 10 (10.0.10.100). For the moment I have Any/Any rules (Protocol = Any, Source = Any, Destination = Any) setup on the firewall for both interfaces but the firewall will still not allow traffic between the two devices. Furthermore what's even weirder is that from 10.0.100.60 I can communicate with a different device on VLAN 10 (10.0.10.208).
Now first look at this scenario says to anyone "It must be an issue with a client firewall on 10.0.10.100." Not only have I confirmed the firewall is off on that device, but as soon as I disable the firewall on pfSense (pfctl -d) I can communicate immediately. Turning the firewall back on (pfctl -e) stops them from communicating. This is confirmed with constant ping.
So I know it's something on pfSense that's blocking me, the question is…what?
-
Are you sure that the pfSense is set as gateway for both clients?
-
Are you sure that the pfSense is set as gateway for both clients?
Yup, both have the gateway set to the VLAN interface (10.0.10.1/10.0.100.1) and their IPs were assigned through DHCP.
-
Post screencaps of your LAN rules for both VLANs.
-
-
Remove the block bogon networks!!! EPEBKAC.
-
-
Try a reboot.
-
Yeah, your LANs should not have Bogon blocks.
-
Check the local firewalls on your damn hosts.
-
Check the local firewalls on your damn hosts.
Did you read the OP? They are off. If they were on, disabling the pf would not allow access like it does.
-
If it was configured like you say it would be working. Check everything again. Stop doing stupid stuff like disabling the packet filter in your firewall.
-
This might sound dumb, but are you sure that your VLAN switch is correctly configured?
Step by step debugging.
Can you ping the pfSense on its VLAN10 interface from VLAN10 PC?
Can you ping the pfSense on its VLAN100 interface from VLAN10 PC?
Can you ping the pfSense on its VLAN100 interface from VLAN100 PC?
Can you ping the pfSense on its VLAN10 interface from VLAN100 PC?The same in the other direction.
ping the PCs from the pfSense. -
If it was configured like you say it would be working. Check everything again. Stop doing stupid stuff like disabling the packet filter in your firewall.
I disabled it for 5 seconds (with my WAN connection unplugged) to isolate the issue. I don't see how that's dumb.
-
You isolated nothing. Without a full understanding of how states are created when you're enabling and disabling the firewall, you really don't know what you were seeing.
Perform simple, basic layer 2/3 troubleshooting.
Again, if it was configured how you say it is it would be working. Check everything. Both hosts, all interfaces, all netmasks, all gateways, all firewalls, etc.
And don't just leave a ping running as a test. When you change your rules start a new one so a new state gets created. Clearing states in Diagnostics > States after changing the rules is another (probably unnecessary) step.