How to Site-to-Site Open VPN Tap (Bridge) Mode
-
Hello
I was trying to setup Site-Site Open VPN with TAP option.
Due to my application limits, I have to keep same subnet at both end.
So all clients at siteB must broadcast to Site A and vice versa, also get DHCP for Site B Clients from Site A DHCP server.I looked into following link. It has nice explanation but only for site A. Other side it uses windows base OpenVPN software in that example. (Client-to-site setup)
Where as i require Site-Site Open VPN. Both end will have PFsense.
https://forum.pfsense.org/index.php?topic=46984.0So i could not figure out what to do at site B side PFsense.
Pls help.
Thanx -
pls help
-
what application is that is that has to broadcast? What is the latency between these sites? I doubt such a crappy application that needs to broadcast is going to work over any sort of latency.
So these sites are using the same ip scheme? Ie you have say 192.168.0/24 on both sides? Even if you connect them at layer 2, your layer 3 has to be the same.
As to your dhcp - the whole point of dhcp relay is to allow for your dhcp servers to be on different layer 2 networks.
Here is a thread from 2014 wanting site to site tap - he got it working and there is instructions in there
https://forum.pfsense.org/index.php?topic=84419.0