<![CDATA[Install to disk: Won't boot]]>

<![CDATA[Install to disk: Won't boot]]>Newb here…

I'm installing pfsense 1.2 to the hard drive of a cisco 500 series content engine.

Everything goes great until I get to the point where I must reboot and remove the cd.

I am then greeted with:

**F1 Linux
F5 Drive 1

Default: F1**

The machine then beeps every few seconds and will not accept any input from the keyboard.

Any advice? What am I doing wrong?

]]>https://forum.netgate.com/topic/10346/install-to-disk-won-t-bootRSS for NodeWed, 15 Jul 2026 01:26:05 GMTFri, 15 Aug 2008 15:41:01 GMT60<![CDATA[Reply to Install to disk: Won't boot on Fri, 15 Aug 2008 19:14:46 GMT]]>Found the problem. These cisco devices have a simm card in them that it tries to boot off. Pulled it out and now all is good.

]]>https://forum.netgate.com/post/179525https://forum.netgate.com/post/179525Fri, 15 Aug 2008 19:14:46 GMT