Lan Interface is not showing up in "By Interface" on Traffic Shaper
-
I am running ver 2.3.2 on an old PC with a USB Network dongle for my LAN interface on my home network. 1 WAN interface via DHCP with IPv4 and IPv6, and 1 LAN static IP.
When running the Traffic Shaping wizards, I get the "There are less interfaces than number of connections!" and it will not run.
When looking at the "By Interface" page in the traffic shaper I only see the WAN interface. Would this be caused by the LAN being the USB dongle?
Any assistance would be appreciated in getting the traffic shaper working.
-
Im having the same issue with a usb connected LTE Modem as a WWAN interface on all my netgate appliances. Im thinking USB devices can not be used for traffic shaping :'(
-
Im thinking USB devices can not be used for traffic shaping
Correct. If they're not supported by ALTQ then you can't use them with shaping.
-
I was able to get this working by changing my hardware over to my virtual server. It is confirmed that it was the USB Dongle causing the issue.