PFsense dynamic vlan
-
Hello,
I am now facing a huge problem.
I run pFsense as router with ubiquiti access point and switch.
I have two SSID :
"Secure" with wpa2 entreprise and radius dynamic vlan;
"Other" with wpa2 personnal (for device such as appleTV, ps4, etc. that don't support wpa2 entreprise;Wpa2 entreprise work like a charm.
But assign a vlan on my "Other" ssid is my problem :
I can't put them it the right vlan.
So they end up on the management vlan.
Is there a way to solve that with pFsense?For now I don't care if it need to be done manually.
I wish I could use radius mac authentification directly on pFsense, but I doubt it's doable.
Regards,
Jonathan -
Are you using pfSense as the default gateway on all your devices or are you doing layer 3 inner-vlan routing on your switch?
-
Are you using pfSense as the default gateway on all your devices or are you doing layer 3 inner-vlan routing on your switch?
I am using pfSense as the default gateway, there is no L3 vlan routing.
Every switch port are trunked to access point. -
There has to have a solution?
-
Solution is to config your switch/ap correctly
-
My access don't support radius mac auth.
Do you think it can be done by a switch even if it's behind an access point?
How?I am looking for a solution.
Regards,
iLevac -
I don't fully understand what you're trying to do, or what exactly "I can't put them it the right vlan" means, but what I can say is that with a WIFI router with DD-WRT installed it's possible to create multiple VAPs (Virtual Access Points) with tagged VLANs on one or more routers. Combine that with a switch that can do VLANs, and you can setup multiple separate WIFI networks that can be managed with pfSense.