Delete NAT
-
I am on release 2.3.3. I needed to move a NAT to a different router. I deleted the rule, the NAT and the Virtual IP and moved this IP to another router. When I saw it would not pass traffic on the new router I looked the the pfSense router firewall log and it showed that the traffic from the deleted NAT was being blocked by the Default deny rule IPv4.
What do I need to clear the NAT data from the router so it will route correctly?
-
Going to need a bit more info dude.. And how is this feedback?
-
Thank you for the quick response. Not sure what there is to add. I had a public IP set up on the router. It was set using a Virtual IP image ps-1, the NAT image ps-2, a fire wall rule image ps-3. I needed to move that public IP to a different router. I deleted the Rule then the NAT and finally the VIP.
When I set up the NAT on the second router the device the public IP was pointed to did not have internet access.
When I went back to the pfSense router the public IP I moved was still routing through the pfSense router even though all references to it were removed, image 4 .If I point the server back to the pfSense gateway an IP check returns the broadcast IP of the router which is what you expect for a device with no NAT. I did try a reboot on the router.
I am working on this remotely and only have access to the router through the GUI.
Any insight would be greatly appreciated.
-
Obviously the IP you deleted on pfSense is routed to another one which is still assigned to pfSense WAN or the ISPs routers ARP table still isn't refreshed.