Multi-Wan PfSense 2.3.4_1 - Englisch
-
Hi!
I have big problems to config my pfsense in dual Wan konfiguration with load balacen… here is my Konfiguration i hope someone can see my failure:
Motherboard Gigabyte N3150N-D3V
4gb Ram
SSD 120gb
Lan Pci card Tp-Link 1gb Model TG-3269Konfiguration:
Wan1 onboard Ipadresse fix Gw Modem
Lan onboard direct to client Fixe Ip Adresse + DHCP - no gateway
Wan2 Tp-Link card over LTE Ipadress fix - Gw LTE-ModemKofiguration on PfSense:
System/Routing/GW:
Wan1 GwModem MonitorIP: 208.67.222.222
Wan2 GwLTEModem MonitorIP: 8.8.8.8System/GeneralSettings DNS:
208.67.222.222 auf Gw-WAN1
8.8.8.8 auf GW-WAN2System/Routing/GW-Groups:
LoadBalance
Gw-Wan1 Tier1
Gw-Wan2 Tier1
Trigger Level: Member downFailover1
Gw-Wan1 Tier1
Gw-Wan2 Tier2
Trigger Level: Packet LostFailover2
Gw-Wan1 Tier2
Gw-Wan2 Tier1
Trigger Level: Packet LostFirewall/Rules/Lan:
LoadBalance
Interface: LAN
Protocol: Any
Sorce: Lan Net
Gateway: LoadBalanceRuleFailover1
Interface: LAN
Protocol: Any
Sorce: Lan Net
Gateway: Failover1RuleFailover2
Interface: LAN
Protocol: Any
Sorce: Lan Net
Gateway: Failover2Rule
I can ping over the webgui Pfsense both Wans and the lan to the internet, but if i go to Status/Gateways ther is always Wan2 down ...
If i plug off a wan than maybee i get the one with the trafic or not ... if its the cabel with the trafic the internet on the client is down ... and no failover happend! This can be Wan1 or Wan2 ... the effect is the same! After plug in again its all normal and i can ping from client ...
What can be the failure, i realy need our help!!! Thanks!!!
-
Noeone has an idea? Please help i think its only a little failure :(!