<![CDATA[Acting as a Repeater]]>Hello,

I have just installed pfSense and want it to act as a Repeater. My setup appears to be different than the other examples I have noticed while browsing through the forums. This is what I am looking to accomplish, though any other suggestions would be most welcome.

Challenges:
Wireless Internet access only available in the Kitchen
Limited funds to purchase additional hardware

Resolution Outlook:
Use pfSense to re-broadcast the signal throughout the rest of the house.

–-------------
Current setup:
Computer with pfSense installed
     Wifi card (D-link)
     NIC (Linksys)
D-Link Wifi Router (connected to the internet)
D-Link Wifi Router  (these are different models)

My original thought was to have the Wifi Internet connection be picked up by the Wifi card in the pfSense box. Then transmit it out the NIC to the Wifi Router to rebroadcast it. Is this even possible using pfSense?

My pfSense Setup for the network interfaces are:
lan -> dc0 - going to the wifi Router to rebroadcast to the rest of the house
wan -> ath0 - Wireless trying to receive the other wireless
opt1 -> plip0 - Unknown

Thanks in advance for the help and suggestions.

]]>https://forum.netgate.com/topic/12633/acting-as-a-repeaterRSS for NodeMon, 13 Apr 2026 23:47:17 GMTMon, 05 Jan 2009 17:22:13 GMT60<![CDATA[Reply to Acting as a Repeater on Tue, 06 Jan 2009 16:59:19 GMT]]>I meant you should connect a directional antenna to the computer (the pfSense) connecting to the accesspoint.
A directional antenna has benefits for both sides.

]]>https://forum.netgate.com/post/187867https://forum.netgate.com/post/187867Tue, 06 Jan 2009 16:59:19 GMT<![CDATA[Reply to Acting as a Repeater on Tue, 06 Jan 2009 16:21:39 GMT]]>I do not have an additional wifi card to put into the pfSense box, also I cannot add a directional antenna to the router as there is another computer that needs the wifi access from the internet router. Though, maybe I am looking too deep in to the problem for the solution…

I am gathering from what you are suggesting is that I set up the pfSense box as a standard router as I would have a single PC attached to the pfSense box. Then everything should work ok?

]]>https://forum.netgate.com/post/187864https://forum.netgate.com/post/187864Tue, 06 Jan 2009 16:21:39 GMT<![CDATA[Reply to Acting as a Repeater on Mon, 05 Jan 2009 23:37:48 GMT]]>Did you try to do it?
I wont give you a step by step howto since this is pretty standard.

If you have problems doing it post here your problems and someone (or i) will help you solve it.

]]>https://forum.netgate.com/post/187803https://forum.netgate.com/post/187803Mon, 05 Jan 2009 23:37:48 GMT<![CDATA[Reply to Acting as a Repeater on Mon, 05 Jan 2009 21:43:44 GMT]]>How would I need to set this up to get it to act the way I explained.
Do I need to set up a bridge?
Do I need to setup the networks on the same subnet or assign each a static IP?

]]>https://forum.netgate.com/post/187797https://forum.netgate.com/post/187797Mon, 05 Jan 2009 21:43:44 GMT<![CDATA[Reply to Acting as a Repeater on Mon, 05 Jan 2009 19:28:18 GMT]]>This should work.
You could also put 2 wireless interfaces into your computer.

Make sure you have a directional antenna on the interface connecting to your internet-providing AP.

]]>https://forum.netgate.com/post/187784https://forum.netgate.com/post/187784Mon, 05 Jan 2009 19:28:18 GMT