Simple site to site, not even ping the server once connected
-
Hi everybody :)
I try to figure out something since a couple of days without success. I’m in an IT position, but not network specialist and English is not my native language which doens’t facilitate the troubleshooting.
For sure I made some searches on this forum and tried some tutorials even in my native language, but without success so far. I would like to be sure to understand what I do.
Thank you by advance for your help.
Scenario.
At work I have a pFSense 2.4 acting as router, an Internet Access (static public IP) on WAN, few computers on LAN on 192.168.2.0/24
At home I have an Internet access and a Synology NAS acting as OpenVPN server, on network 192.168.1.0/24, VPN clients get 10.8.0.0/24
I would like, from the LAN at work on 192.168.2.0/24, access home resources on 192.168.1.0/24
It’s working fine with OpenVPN Gui (on the Synology I checked the box to « enable access to local nework »).I would like to build a simple site to site so no need to use OpenVPN Gui anymore.
In VPN client / Tunnel settings I put :
IPv4 Tunnel Network : 10.8.0.0/24
IPv4 Remote network(s) : 192.168.1.0/24
Settings as General Information / User auth / Cryptographic are correct as I’m connected: picture attachedI created a rule Firewall / OpenVPN : picture attached
Here is what I have in Firewall / NAT / Outbound, I understood it could be important… : picture attached
Here is a ping from OpenVPN virtual interface to the VPN server (10.8.0.5) :
I'm sure I missed a step, and it's probably obvious for you but... I'm blocked...
Thank you for your good advices.
Antoine.
-
Hi gentlemen,
not able to figure out so far…
However my route table seems fine doesn't it ? ???
Sure I'm not far from the end, seems so simple, did I miss something ?
Thanks.