WAN IPv6 Address Not Acquiring
-
I am having an issue getting my WAN to get an IPv6 address that sticks around. When I'm troubleshooting it I will disable the DHCP6 on the WAN interface then turn it on and occasionally it'll get an IPv6 address then when I try to figure out what I changed to get it to get an IPv6 address i'll disable it then turn it back on and it wont get the address again. If I plug the cable modem direct to my computer it gets an IPv6 address automatically every single time without fail but pfsense doesn't seem to want to keep/acquire an address.
I've done a ton of googling on the issue for the past few hours but everything I came up with has no proved to be fruitful.
Any suggestions to get IPv6 to stick around? Is there anything I should check/try to keep this functioning?
-
Is it possible that I kept sending release requests too frequently and once I dismissed the IPv6 address there is a timeout on my ISP side before they will reissue the addresses?
I'm going to disable IPv6 and do something else and come back later to re-enable it and see if that resolves the issue or not.
-
https://forum.netgate.com/topic/133955/unable-to-obtain-v6-address-on-wan-without-having-lan-enabled-for-tracking
-
Ok, so that kind of worked. I was able to re-enable IPv6 and resubmit the LAN interface for tracking and it updated the IPv6 address to an actual IPv6 address. Weird.
-
yeah, seems to be a bug in the way the DHCPv6 client config file is generated
not sure if it's been confirmed or not
-
Ok so I rebooted after installing pfblockerng and now I can’t get my ipv6 address back again ️