tunnel over slash 48
-
I have an he.net tunnel broker setup and working with their assigned /64.
However, I also have a /48 assigned on the same tunnel. Unfortunately, i cannot get any traffic to route over that /48 tunnel. Tunneling from an IP on the /64 source works fine.
What needs to change on my config to get pfSense to route the /48 network over the same tunnel?
-
The /48 should be routed the same as the /64. Just assign a /64 block from your /48 to an interface and it should work for clients connected to that interface.
Also make sure the he.net tunnel gateway is set as the default gateway for IPv6.
-
Thanks for the sanity check.
I got a few IPv6 digits reversed. Fixing the typo fixed the routing. :)