Same Remote Gateway but different source IP - VIP
-
Hi guys,
I need your advice.
I already have 2 tunnels configured with same remote ip, for example 8.8.8.8 where as a source interface i used 2 different virtual ip's (example 1.1.1.1 and 2.2.2.2). Phase 2 subnets are different.
During initial configuration pfsense didn't complained at all and this should be considered as 2 different tunnels if i am not wrong.
Now if i want to edit any of this 2 tunnels i get the message
The following input errors were detected:
The remote gateway "8.8.8.8" is already used by phase1 "
Also, after pfsense reload in order to have them both working, the one created after has to be disabled so older one gets connected and than i can enable second as well.
Any ideas, workaround ?
Thank you in advance.