<![CDATA[vLAN Setup Issue]]>I have SG-5100 and Netgear GS716Tv2. GS716Tv2 Port 1 is connect to SG-5100 LAN. GS716Tv2 Port 5 is untagged with vlan 30. So far I getting the assign ip address 192.168.30.*. I also can access the web. The issue right now is that I can't access vlan30 fron LAN. I created rule following to allow access from LAN to vlan30:

  • Action: Pass
    Interface: LAN
    Address Family: IPv4
    Protocol: Any
    Source: LAN net
    Destination: vlan30 net

On vlan30 rules:

  • Action: Pass
    Interface: vlan30
    Address Family: IPv4
    Protocol: Any
    Source: any
    Destination: vlan30 net

  • Action: Pass
    Interface: vlan30
    Address Family: IPv4
    Protocol: Any
    Source: vlan30 net
    Destination: any
    Gateway: WAN_DHCP

I'm not sure what I'm missing. I follow the same steps that I did with subnet on one of the port on sg-5100 to allow access between subnet.

]]>https://forum.netgate.com/topic/160884/vlan-setup-issueRSS for NodeWed, 07 Oct 2026 04:08:41 GMTMon, 15 Feb 2021 22:15:38 GMT60<![CDATA[Reply to vLAN Setup Issue on Wed, 17 Feb 2021 04:15:33 GMT]]>@nevar i was able to figure out the issue. it is noob mistake. i forgot that starting windows10, ping is disable by default argh. after realizing that, i install portable ftp server on my pc that is on vlan and then try connect to it from my lan. i was able to connect to it. i also do couple test with the rule set to disable/enable and it work as expected.

]]>https://forum.netgate.com/post/964219https://forum.netgate.com/post/964219Wed, 17 Feb 2021 04:15:33 GMT<![CDATA[Reply to vLAN Setup Issue on Tue, 16 Feb 2021 03:36:42 GMT]]>@nevar I want to addition info that I can access LAN from vlan30 when I added rule, but I still not able to access vlan30 from LAN.

]]>https://forum.netgate.com/post/964026https://forum.netgate.com/post/964026Tue, 16 Feb 2021 03:36:42 GMT