Destination Network
-
How to setup this network type I'm having trouble.
I already setup the network & the OpenVPN and it's already working, but the IP is still showing when i go to ipchicken is still the IP of the phone.
I want to be the WAN ip of phone we be showing to WAN because it's already connected to OpenVPN.
I already setup also in rules > OpenVPN> the destination is WAN Net but not still appearing the IP of WAN.
-
@vincent_28
The reason might be a missing route on the client.To direct internet traffic over the vpn, check "Redirect gateway" in the server settings.
Also ensure that pfSense has added an outbound NAT rule for the OpenVPN tunnel network. In the picture there might be a typo in the vpn network, the shown is a public IP.@vincent_28 said in Destination Network:
I already setup also in rules > OpenVPN> the destination is WAN Net but not still appearing the IP of WAN.
This does not allow internet access. WAN net is only the subnet of your WAN IP. So if it's a /32 (PPP), there is nothing else included.
You need to set the destination to "any" in the pass rule. If you want to prohibit access to your LAN add an additional block rule for that destination to the top of the rule set.