NG 3100 forgot which port used
-
Stupid issue.... It's been a while since I have had to log in to my Pfsense FW and I set it up to use a non standard port. I lost all my network documentation and need to log in to the pfsense interface but can't figure out what port I used to connect to gui. Is there an easy way to figure out what port the device is communicating on?
-
@spearhead1 Well, I happened to have NMAP/ZENMAP installed, that seemed to work ok. Just put in the LAN address of PFSense, chose 'Quick scan' and can see three ports open.
-
Connect to the serial console, or ssh if you enabled that, and run:
sockstat -l4 | grep nginx
That will return the ports nginx is listening on.
Steve
-
@stephenw10 said in NG 3100 forgot which port used:
That will return the ports nginx is listening on.
@stephenw10 thank you, fixed it!