<![CDATA[NAT with public routed pool]]>Hello,

I am new to the forum but not new to pfsense. So far I was able to realize several setups with multiple WAN and LAN segements fine. The task on hand is somehow much more complicated.

Background: for a large wifi installation several private LAN segments shall be NATed indiviually to public IPs thar are provided by our ISP. Therefore a /28 public IP block is routed to one of our our WAN addresses by our ISP (we have a different /26 block there). We want to use other IPs for the the solution for internal reasons. We have done such a setup once but used Juniper SRX routers wich is not possible in this case for monetary reasons. We have a dedicated box for the given solution.

Given IPs (as private for privacy reasons)
pfsense WAN: 10.1.61.203/26
WAN ISP GW: 10.1.61.254/26
routed IP block: 192.168.2.48/28
simple static routing configured in ISP router
client segments: 172.20.[0|8|16|24].0/21 in separate VLANS directly attached

We planed for four individual NAT pools with 4 public IPs each wich is used by a larger private segment behind.

The hint or direction to a maybe existing writeup of somethin is someho concentrating of how to get pfsense to route the IP block (firewalling/filtering shall be made during NAT) to our ISP and make it usable for the NAT pools?

We already tested NAT pools with some other of our main public adresses but did not really see the round robin working as we did have only a few clients availabe this time. Testing it with something like Cisco's TRex system might be overfill and very timeconsuming (would be a first for us).

Thkans in advance for any hint!
MP.

]]>https://forum.netgate.com/topic/166172/nat-with-public-routed-poolRSS for NodeSun, 11 Oct 2026 03:04:37 GMTSun, 29 Aug 2021 12:12:09 GMT60<![CDATA[Reply to NAT with public routed pool on Wed, 01 Sep 2021 18:21:54 GMT]]>@viragomann
I am stunned... THAT was an easy trick. Damn. Though much more complicated stuff involved...
Thank you very much!
Now I have to figure out why NAT-Pool with HASH is not working properly, the GUI does not accept the setting with a pool of four of the named adresses. Strange.
Again, thank you!
MP.

]]>https://forum.netgate.com/post/999766https://forum.netgate.com/post/999766Wed, 01 Sep 2021 18:21:54 GMT<![CDATA[Reply to NAT with public routed pool on Tue, 31 Aug 2021 21:06:43 GMT]]>@mp45
You have add each IP of your /28 block as virtual IP of type IP Alias to your WAN. Then the IPs can be used in the outbound NAT settings.

For instance to NAT 172.20.0.0/21 to the 192.168.2.48/30 pool, simply add an outbound NAT rule where the source is 172.20.0.0/21 and the translation address is other subnet > 192.168.2.48/30 and select the proper pool option.

]]>https://forum.netgate.com/post/999599https://forum.netgate.com/post/999599Tue, 31 Aug 2021 21:06:43 GMT