Every time I enable the IPv6 neighbour, it also updates the IPv4 BGP routes with incorrect information ignoring next hop, route maps, and anything else that can be used to control the BGP routes.

Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd PfxSnt
xx.xx.xx.34 4 203315 1044019 2998 0 0 0 01:08:07 911233 9
xx.xx.224.17 4 174 610563 3171 0 0 0 1d00h54m 907002 9
xxx.xx.47.189 4 3356 730734 2996 0 0 0 1d00h54m 910111 9
xx:xx:2:78::68:1 4 174 495335 38268 0 0 0 1d00h54m NoNeg
xx:1xx:2:2:0:8:7d75 4 3356 354241 38267 0 0 0 1d00h54m NoNeg
xx:xx:aba::34 4 203315 1334287 2942 0 0 0 00:04:13 911217 9

The only way I have found to stop this is to manually edit the frr.conf and add the following;

no neighbor <IPv6 address> activate

The problem, then, is that any GUI changes are ignored.

Is there any way to set this through the GUI, or are there any other alternatives that I can use to stop the IPv6 neighbour from updating the IPv4 address family?