Netgate 8200 WAN 4 interface ix1 trunk port no mac address 00:00:00:00
-
Hello,
I configure the WAN 4 10GB port as a trunk port connect to down stream switch (Extreme). The physical layer it's indicated green lights but no traffics passing through.
I am not sure whether is the 10GB SFP+ module compatible or not.** Noticed I used the same 10GB SFP+ modules on other WAN 3 interface and it's operates normal.
WAN 4 ix1 -- no IP address
VLAN101 -- 10.200.101.1/24
VLAN102 -- 10.200.102.1/24
VLAN201 -- 10.200.201.1/24Here's the interface status
CONTROLS_NETWORK Interface (opt3, ix1)
Status
up
MAC Address
00:00:00:00:00:00
IPv6 Link Local
fe80::92ec:77ff:fe95:d16f%ix1
MTU
1500
Media
Unknown <rxpause,txpause>
Plugged
SFP/SFP+/SFP28 10G Base-LRM (LC)
Vendor
FS PN: SFP-10GLRL-31 SN: G2430373200 DATE: 2024-08-23
Temperature
40.25 C
Voltage
3.28 Volts
RX
0.91 mW (-0.40 dBm)
TX
42.58 mA
In/out packets
0/0 (0 B/0 B)
In/out packets (pass)
0/0 (0 B/0 B)
In/out packets (block)
0/20 (0 B/868 B)
In/out errors
0/0
Collisions
0