NAT Source network for VPN
-
Hi,
I have to setup a VPN with another company - our internal address ranges clash so they are asking me to NAT our source network to a specific single IP that they supply eg. 10.255.166.1 - is this possible with PFsense & if so how would I go about doing it ?
Many thanks
-
With OpenVPN this is possible.
Not sure about IPSEC.You would assign the OpenVPN interface as an OPT.
Then enable Advanced outbound NAT and enable NATing for the OpenVPN interface. -
Unfortunatley I need to use IPsec
-
Did anyone find a solution to this? I have the same problem at one of my customers locations.
They have LAN addresses which are already in use at the remote location. I would like to source NAT the IPSec connection to the firewall's WAN address or similar. -
There is no solution for IPsec right now. It's a limitation of the underlying software.
There was a bounty open with a proposed solution but the funding was removed before any work could be completed, and it required some lower-level changes in C code in the software being used.
Check the expired bounties forum for more details.