Bandwidth Aggregation w/ 2 Cable Modems w/ Intermediary NAT Q?
-
Was just reading the pfsense book and it said that to load balance 2 cable modems for bandwidth aggregation, i needed some sort of intermediary NAT device? What device? Does anybody have an example setup similar to this I could compare to? Its merely 2 cable modems w/ dynamic addresses? Anyone care to shed a little light on this when they get a chance?
thanks
-m
-
This only applies if your WANs have the same gateway.
Do they?
Otherwise you're going to be fine by just connecting the modems to the pfSense. -
ahhhhh so if these modems have routing functionality built in, could I disable dhcp on both of them, assign them unique statics on different subnets, i.e modem1: 192.168.80.1 and modem2:192.168.81.1 and then plug them both into a dumb switch and plug it into my wan interface? If not, i'm going to have to slap another nic card in this box… can I slap another nic into pfsense without re-installing?
-m