Can not access lan or inbound
-
I've only been using ver 2 for a few days, and am running it with in a KVM. So my issues may be due to a misconfig or kvm.
However we have used kvm for over a year to run some servers. BUt this is the 1-st bsd under kvm for us.
The issue I have is that access to LAN stops after some hours.
I can get to psense from KVM console to test ping.
can ping out using WAN
can not ping the LAN network.
can not access webguiFrom a computer on the LAN, i can not ssh into pfsense.
To fix I have to reboot .
then all the above works.the nics are e1000
i just rebooted and here is the version status:
2.0-RC1 (amd64)
built on Sat Apr 9 14:48:31 EDT 2011Update available. Click Here to view update.
so I'l update and get back with results.
-
after the upgrade:
work:
access webgui from off site
ssh from lan to pfsense
ping lan and wan from consolenot working:
ssh in from offsite. i use port 5922 and have a nat rule. this worked last night. i tried rmv and re add the nat/rule. same result
ping from offsite. i just added the rule to wan. will re check syntax
I am using 64bit ver. is 32 better to test?
and I can give access to this test system if testing want to be done by devs.
-
after the upgrade:
. . .
not working:ssh in from offsite. i use port 5922 and have a nat rule. this worked last night. i tried rmv and re add the nat/rule. same result
ping from offsite. i just added the rule to wan. will re check syntax
Anything relevant in the firewall log? Does a packet capture on the WAN interface show a ssh access attempt?
-
the logs did show the rule worked .
However getting I could not get to the target computer. the thing is I could at times..
I'll have tried rc-1 and daily updates [ as of Sat].
My issues were that I could connect, and later not.
I probably have something not setup correctly… I have used V1.23 for years..
To eliminate the possibility that my issues are KVM related, I'll install 1.23 in a kvm, restore our current production config, change the addresses and make sure that works.
If you have any suggestion please respond.
-
A few hours ago I made adjustments to gateway , nics and upgraded to latest snapshot, and problems are solved.
the issues were possibly caused by adding a 3-rd nic and not configuring it correctly.
in addition the lan has another pfsense running in production, and most computers use that as the gateway.
i was having issues with port forward to computers which had the other pfsense set as their router.