I've just installed 2.0 RC1 on a Dell PowerEdge 1850.  This server was previously in production using v1.2.3 and running fine.

I don't get far into the web configuration before I start having issues…

The 1st thing I did is go to the Advanced tab and set the notification info for email.  When clicking save, it takes between 30 - 45 seconds before I can continue (Is this normal?).  Then I go to the General Setup and set the hostname, etc.  When clicking save, this takes about 15 seconds (OK, better).  Then I go to start configuring my gateways and static routes.  I can get through creating the Gateways without issue.  But, when I start creating static routes, I have all kinds of problems.  Either after clicking Save or Apply Configuration, my web browser will time out.  I won't be able to reconnect that session for 1 to 2 minutes.  It will then reconnect, but the page I was working on did not save.  I can usually get 1 route in at a time before this process repeatedly happens.  Now, as soon as my browser is timed out, I can close the browser, re-open it and get logged in no problem.  However, I can only make about 1 change before I get timed out again.

Now, back at the console.  When this happens, my CPU usage in nothing.  However, if I watch the filter logs, as soon as I am timed out, I see a ton of the following:

rule 2/0(match): block out on em0:  192.168.13.1.443 > 192.168.13.4.xxxxx:  tcp 4 [bad hdr length xx - too short, < 20]

(The X's are random numbers)

Can anyone help out here?

Thanks,

Jeff