Automatic outbound NAT not NAT'ing any outbound packets
-
Hi,
We have a situation where "Automatic outbound NAT rule generation" is not translating the source IP of any outbound packets.When I change to "Manual Outbound NAT rule generation" all instantly works fine. Ive seen this on the last two fresh installs of pfsense version 2.0-RC1.
The attached is the working setup where I can ping from the inside router thorough the firewall to the outside. This same test does not work in automatic mode. I have captured some packets and the source is not being NAT'ed.
Has anyone seen this and know what is going on here?
Regards,
Kent.

 -
You should use rc3
-
Thanks for the info. Is this a known issue with RC2?
-
It's not issue in any rc i've tested, but here in common if you're asking help you should have always updated to the latest build. There are always lot of changes between snapshots.
Have you updated? does this problem exists?
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register LoginPrivacy Policy · Cookie Policy