<![CDATA[WRAP: 1 eth for dual wan]]>Hello,

i have a WRAP board with 2 lan interfaces. one for wan and one for lan.
now i want to connect TWO internet lines (static ip - same subnet) to the ONE wan (ok using a switch to get the two ports) port and make load balanching. is this possible and when yes who to setup? i can change the ip from the ISP if necesarry.

picture:

ISP1 - 10.10.10.1  – 1 WAN from WRAP -- LAN WRAP -- 192.168.X.Y
ISP2 - 10.10.10.2  --

Martin

]]>https://forum.netgate.com/topic/366/wrap-1-eth-for-dual-wanRSS for NodeThu, 16 Apr 2026 06:02:15 GMTWed, 04 Jan 2006 14:15:36 GMT60<![CDATA[Reply to WRAP: 1 eth for dual wan on Sun, 12 Feb 2006 21:14:15 GMT]]>depending on what you have on the wan side.
you could have two vlans tagged to the wan interface.

then just tag your switch on a port for  each vlan and add a port for each of your wan connections.

as scott said use two differnet subnets

]]>https://forum.netgate.com/post/134317https://forum.netgate.com/post/134317Sun, 12 Feb 2006 21:14:15 GMT<![CDATA[Reply to WRAP: 1 eth for dual wan on Sun, 12 Feb 2006 21:06:49 GMT]]>Not sure this will work.  You'll need to breakup the 2 subnets on 2 interfaces.

I've seen reports of tricks flying around in the forum but I cannot speak for them so you'll need to do some searches for more information.

]]>https://forum.netgate.com/post/134316https://forum.netgate.com/post/134316Sun, 12 Feb 2006 21:06:49 GMT<![CDATA[Reply to WRAP: 1 eth for dual wan on Sun, 12 Feb 2006 21:05:20 GMT]]>Hello,

the problem is the default gateway in the rule. i can only set it to default. but for some rules i have to set them to gateway1 and for others to gateway2.
i only have one wan interface !

Martin

]]>https://forum.netgate.com/post/134315https://forum.netgate.com/post/134315Sun, 12 Feb 2006 21:05:20 GMT<![CDATA[Reply to WRAP: 1 eth for dual wan on Thu, 09 Feb 2006 22:16:04 GMT]]>http://www.pfsense.org/mirror.php?section=tutorials/policybased_multiwan/policybased_multiwan.pdf

]]>https://forum.netgate.com/post/134224https://forum.netgate.com/post/134224Thu, 09 Feb 2006 22:16:04 GMT<![CDATA[Reply to WRAP: 1 eth for dual wan on Thu, 09 Feb 2006 07:07:46 GMT]]>no one a solution for this problem?

when one line is fall back is there any possibility to change the gateway in the WRAP with a sh script when it recognized with ping that one ISp is down?

Martin

]]>https://forum.netgate.com/post/134204https://forum.netgate.com/post/134204Thu, 09 Feb 2006 07:07:46 GMT