<![CDATA[Routing Traffic through Specific WAN]]>I have a setup with dual PPPoE WAN and I am trying to find the correct way to route traffic per application to specific WAN.

Let's say I want to make SoulSeek that uses port 1369 to pass through WAN 2.

Will a firewall rule on LAN interface with the specific port and under Advanced:Gateway, WAN 2 selected do the job?

Where do I put the port, Source port range or Destination port range?

Also since the outgoing will be on WAN 2 IP, the incoming will use the same IP with no further rules?

Any tips are greatly appreciated cause I'm not really a network guru, trying to figure it out with any info I can get on the forums.

]]>https://forum.netgate.com/topic/38503/routing-traffic-through-specific-wanRSS for NodeFri, 16 Oct 2026 08:14:08 GMTSun, 23 Oct 2011 15:30:10 GMT60<![CDATA[Reply to Routing Traffic through Specific WAN on Sun, 23 Oct 2011 15:41:07 GMT]]>That was fast! Thanks a Lot  ;D

]]>https://forum.netgate.com/post/301276https://forum.netgate.com/post/301276Sun, 23 Oct 2011 15:41:07 GMT<![CDATA[Reply to Routing Traffic through Specific WAN on Sun, 23 Oct 2011 15:36:41 GMT]]>q: Will a firewall rule on LAN interface with the specific port and under Advanced:Gateway, WAN 2 selected do the job?

a: yes

q: Where do I put the port, Source port range or Destination port range?

a: destination

q: Also since the outgoing will be on WAN 2 IP, the incoming will use the same IP with no further rules?

a: yes incoming will use the same wan ip, not need any rule

]]>https://forum.netgate.com/post/301275https://forum.netgate.com/post/301275Sun, 23 Oct 2011 15:36:41 GMT