Routing Traffic through Specific WAN
-
I have a setup with dual PPPoE WAN and I am trying to find the correct way to route traffic per application to specific WAN.
Let's say I want to make SoulSeek that uses port 1369 to pass through WAN 2.
Will a firewall rule on LAN interface with the specific port and under Advanced:Gateway, WAN 2 selected do the job?
Where do I put the port, Source port range or Destination port range?
Also since the outgoing will be on WAN 2 IP, the incoming will use the same IP with no further rules?
Any tips are greatly appreciated cause I'm not really a network guru, trying to figure it out with any info I can get on the forums.
-
q: Will a firewall rule on LAN interface with the specific port and under Advanced:Gateway, WAN 2 selected do the job?
a: yes
q: Where do I put the port, Source port range or Destination port range?
a: destination
q: Also since the outgoing will be on WAN 2 IP, the incoming will use the same IP with no further rules?
a: yes incoming will use the same wan ip, not need any rule
-
That was fast! Thanks a Lot ;D