No PPTP or SSH after changing WAN interfaces
-
Hi all,
today I changed my Dual WAN Setup. The old setup was WAN1: PPPOE WAN2:Static. My new setup should be WAN1: Static WAN2: PPPOE.
So I relocated the physical lines of the ethernet ports and changed the config for WAN1 to static. I deleted the routing groups for Dual WAN.
The state is now that my static WAN1 is up and seems to work ok from inside.
Now my Problem: From outside I can´t connect to via PPTP or SSH. But I can´t connect. Also SSH doesn´t work from outside. The corresponding firewall rule is the same as before changing my setup. (I didn´t touch it.)
Is it possible that pfsense doesn´t see my WAN1 as the WAN1 so that the firewall route doesn´t match and PPTP doesn´t listen? As far as I know, PPTP is only listening on WAN1.
Any suggestions?
Thanks in advance! -
In some cases, after swaping interfaces config, you may need a reboot.
Check first if rules in wan are not assigned to old wan ips.
-
I did some reboots. Switched off and on PPTP.
In the rules I don´t use IP´s, such the interface…. -
YIPPI!
After setting up WAN2 and another reboot, WAN1 works as it should!So this topic can be closed!
Thanks!