<![CDATA[Filter traffic from IP]]>Hi, got a LAN with a bridge (one local 192.168.1.10 and one remote 192.168.1.20)from one location to another, and we share the same LAN.
I need to block the traffic that came across the bridge, but need to be able to connect from local to the other side of the bridge.
I cannot separate the LAN, it is possible to make a rule to filter the traffic incoming from the 192.168.1.10 and 192.168.1.20?
Any advice is really appreciated, please link me a guide or article.

]]>https://forum.netgate.com/topic/39950/filter-traffic-from-ipRSS for NodeSun, 11 Oct 2026 03:21:35 GMTTue, 13 Dec 2011 10:10:45 GMT60<![CDATA[Reply to Filter traffic from IP on Tue, 03 Jan 2012 15:51:39 GMT]]>Hi sorry for the delayed reply, it means that adding a NIC and connecting the 192.168.1.10  local access point of the bridge to the NIC, I can filter the traffic that came in the LAN passing by the 192.168.1.10?

so I can make a firewall rule that says block interface OPT source 192.168.1.10  destination all -  that block all traffic caming from the ap.
and other rules that make the traffic pass for certain Ip.
is this correct?

about the bridge I haven't disabled the filtering.

]]>https://forum.netgate.com/post/311994https://forum.netgate.com/post/311994Tue, 03 Jan 2012 15:51:39 GMT<![CDATA[Reply to Filter traffic from IP on Tue, 13 Dec 2011 14:29:56 GMT]]>You can block only if the traffic is destined for the other side of the firewall. In your case, I think you need to specify source IP and destination IP so you don't end up blocking everything.
For your bridge, did you disable filtering (the firewall) in the advanced properties?

]]>https://forum.netgate.com/post/308478https://forum.netgate.com/post/308478Tue, 13 Dec 2011 14:29:56 GMT