[Resolved] Advice on comcast setup
-
Greetings,
I am setting up a single WAN scenario. Please see below:(WAN/Comcast network)
|
[Cable Router]
| (public CIDR/28 address space)
[pfSense Router]
/ |
/ (DMZ)
/ (WLAN private)
(LAN private)What I'm trying to accomplish is to have the DMZ utilize the same CIDR /28 address block that exists on the WAN side of the pfSense Router. I'm trying to find out the most efficient way of doing this, be it setting up a VLAN, setting up a bridge, etc. Anyone have any thoughts?
I've seen posts mention CARP and virtual IP addresses, but unfortunately I don't know what these are.
Thanks in advance for your help!!
-Herald -
Found the answer in the book "The Definitive Guide to pfSense". I'm not wild about how the book is laid out, but it had the information I needed…Guess it turned out to be a $35.00 question. If you're looking to do the same configuration, I'd go read that book.
-Herald