Few PBlocker problems with setup
-
Hello all,
I just installed pfblocker for a second time on my system and had the same results.
Background:
Two Pfsense 2.01 FW with Muti WAN. (multiLan)
On installation, it would appear everything is ok, once I start selecting block rules, the system will start to give errors like, can load rules. (Note: Before I even installed PFBlocker I adjusted Maximum number of table entries for systems such as aliases, sshlockout, snort, etc, combined. To 999999999)
I had to rebuild the boxes and restore a working config prior to pfblocker installation. (Both times)
What was happening:- Second Carp FW would respond to ping, but I could not get to web gui.
- All traffic out was blocked
- First FW gui was a bit slow to respond
- PFBlocker Rules would appear twice on my WAN Interfaces (both fw)
Specs for both boxes:
Version 2.0.1-RELEASE (i386)
built on Mon Dec 12 17:53:52 EST 2011
FreeBSD 8.1-RELEASE-p6Platform pfSense CPU Type Intel(R) Core(TM)2 Quad CPU Q9400 @ 2.66GHz
4GB Ram
Since this happened on two clean installs, I am not sure what I am doing wrong.
Any help would be great.
Thanks in advance -
ok, same thing just happened again.
Anyone else having this problem.
thx