Rolls stop working after hardware failure
I have pfsense box installed with 4 networks
1 wan X.X.X.X
2 LAN 172.16.10.0/24
3 LAN 172.16.11.0/24
4 LAN 192.168.2.0/24
i had an hardware failure and i needed to replace the board
and know i am having problems with block rolls on the LAN interfaces
I have setup a block rolls on each LAN so that no LAN network will have access to the other the thing is that after a reboot the rolls stop working after a 1 hour or so
When I reboot the box the rolls are working and stopping after 1 hour
Thanks in advanced Daniel
![Pf rolls.png](/public/imported_attachments/1/Pf rolls.png)
![Pf rolls.png_thumb](/public/imported_attachments/1/Pf rolls.png_thumb)
So what you are saying is that after 1 hour, you are able to access the other 2 LANs?
What hardware did you have to replace? Was a re-install completed?
What version are you running? Is there anything in the log files that might indicate why the rules are not being followed?
I needed to replace the motherboard as far for the system log or the FW log cant see anything wrong in there
after i replaced the motherboard i started the FW and the FW as booted with no problems
but i needed to replace a NIC for one of the LAN interfaces
i am running the 2.0.1
Hi i have taken a second look at the FW settings and found my mistake
thanks for the replay