Pfsense embedded with snort and squid
-
I'm using an embedded Pfsense build with the following setup:
Alix2d13 board
CPU: 500 MHz AMD Geode LX800
DRAM: 256 MB DDR DRAM
3 Ethernet ports
1 miniPCI expansion slot
2 USB
2 GB CFI want to experiment with Snort and Squid. Are these packages possible on embedded systems? If so, can you give me some tips or link me to a guide/documentation that would assist me on this.
Using a full blown install really isn't an option on a PC or VM isn't an option.
-
I can't answer your question (I run a full install… not embedded)... but I want to make a comment about your memory selection. I run pfSense at home with only 3 users and squid + snort use consistently between 3 and 4 GB of memory. I think you'll have a bad time with only 256 MB of memory.
-
Snort and Squid are not recommended in embedded installations. You will have memory hogs. Also Squid needs disk space for caching, which is not much in CF card installations.
Best regards
Kostas
-
Snort and Squid are not recommended in embedded installations. You will have memory hogs. Also Squid needs disk space for caching, which is not much in CF card installations.
Best regards
Kostas
I agree for Snort. It can easily consume more than 1 GB of RAM just by itself with a moderate rule set. I've had some 1 GB RAM virtual machines used in my Snort testing start swapping out to disk with Snort and a full set of rules running.