2.1-RC1 (i386)
built on Thu Aug 1 19:03:40 EDT 2013
FreeBSD 8.3-RELEASE-p9

I'm wondering if the bouncing of the prom mode on my FE interface is eventually causing the nic/os to crash. Can I disable prom mode temporarily to check? Any other suggestions?

crash output.
<6>pppoe0: promiscuous mode disabled
<6>pppoe0: promiscuous mode enabled
<6>pflog0: promiscuous mode disabled
<6>pflog0: promiscuous mode enabled
<6>pflog0: promiscuous mode disabled
<6>pflog0: promiscuous mode enabled
<6>pflog0: promiscuous mode disabled
<6>pflog0: promiscuous mode enabled
<6>pflog0: promiscuous mode disabled
<6>pflog0: promiscuous mode enabled
<6>pflog0: promiscuous mode disabled
<6>pflog0: promiscuous mode enabled
<6>pflog0: promiscuous mode disabled
<6>pflog0: promiscuous mode enabled
<6>pflog0: promiscuous mode disabled
<6>pflog0: promiscuous mode enabled
<6>pflog0: promiscuous mode disabled
<6>pflog0: promiscuous mode enabled
<6>pflog0: promiscuous mode disabled
<6>pflog0: promiscuous mode enabled
<6>pflog0: promiscuous mode disabled
<6>pflog0: promiscuous mode enabled
<6>pflog0: promiscuous mode disabled
<6>pflog0: promiscuous mode enabled
<6>pflog0: promiscuous mode disabled
<6>pflog0: promiscuous mode enabled
<6>pflog0: promiscuous mode disabled
<6>pflog0: promiscuous mode enabled
<6>pflog0: promiscuous mode disabled
<6>pflog0: promiscuous mode enabled
<6>pflog0: promiscuous mode disabled
<6>pflog0: promiscuous mode enabled
<6>pflog0: promiscuous mode disabled
<6>pflog0: promiscuous mode enabled
<6>pflog0: promiscuous mode disabled
<6>pflog0: promiscuous mode enabled
<6>pflog0: promiscuous mode disabled
<6>pflog0: promiscuous mode enabled
<5>fxp0: link state changed to DOWN
<5>fxp0: link state changed to UP
<5>fxp0: link state changed to DOWN
<5>fxp0: link state changed to UP
<6>pid 73870 (squid), uid 62: exited on signal 6
<6>pppoe0: promiscuous mode disabled
<6>pppoe0: promiscuous mode enabled

Fatal trap 12: page fault while in kernel mode
cpuid = 0; apic id = 00
fault virtual address = 0xc
fault code = supervisor read, page not present
instruction pointer = 0x20:0xc0af7a83
stack pointer         = 0x28:0xe6225ae4
frame pointer         = 0x28:0xe6225afc
code segment = base 0x0, limit 0xfffff, type 0x1b
= DPL 0, pres 1, def32 1, gran 1
processor eflags = interrupt enabled, resume, IOPL = 0
current process = 12 (irq17: fxp0 bfe0)
version.txt06000023712212764173  7622 ustarrootwheelFreeBSD 8.3-RELEASE-p9 #1: Thu Aug  1 19:31:55 EDT 2013
    root@snapshots-8_3-i386.builders.pfsense.org:/usr/obj.pfSense/usr/pfSensesrc/src/sys/pfSense_SMP.8

jsbsmd