IPSEC TUNNEL FROM LINKSYS WRV54G TO PFSENSE
-
I'm setting up a site to site tunnel from the hr office to home office. I setup the vpn the same but when I try to connect the vpn. I am getting waiting on connection. My pfsense firewall drops all the vpns. I have to reconfigure the tunnel. Please help.
-
Some time ago i prepared configuration like this - pfsense at work, WRV54G at home. It was a bit unstable - some time it keeps ipsec tunnel up and running for 2-3 days, sometimes ipsec tunnel traffic stops after 2-3 hours. It is always possible to press <disconnect>and <connect>button in WRV54G configuration screen. Finally I dropped Linksys stuff at home and prepared second soekris board. Now tunnel is up and running 43 days, - since last reboot at home.
p.s. WRV54G can not act as dynamic (mobile) ipsec client, so You have to put all addresses as static at both ends.</connect></disconnect>
-
I don't recall the model for sure, but I did setup a Linksys VPN device recently. It's working fine, but I had to upgrade to the latest firmware on the Linksys first, it had some IPsec bugs that prevented it from working properly.
-
I just set one up. it working fine. it's very stable and extreamly fast.
-
How did you set it up? I'm having nothing but problems
-
my client has a static address on his end and i have one two on my side. I have no issues. It was a pain to get just right but I am finding everyvendor has slightly different terms for the same thing and it will drive you nuts.
In my case it was a typo. I had the wrong IP set up. changed it and up it came. it's been working fine.
RC