Pfsence with router
-
I have a network with this Structure(please see this picture)
I have some modems that connect to internet and then connect to firewall(pfsence)
firewall Output must connect to router and router Output must connect to Main switch and main switch connect to some switch and finally the client are there.
the reason for using the router is that the network uses the VLAN and then it must has router.
The problem is that the IPs and client MAC don't reach to firewall and can't set down on it.

-
the reason for using the router is that the network uses the VLAN and then it must has router.
Why not just use VLAN interfaces in pfSense directly?
The problem is that the IPs and client MAC don't reach to firewall and can't set down on it.
I don't really understand what you're asking here. Which IPs? On the LAN side?
Please add more details.
Steve
-
On pfSense Firewall you will need:
a) System->Routing, add a gateway pointing to the Router.
b) Routes - add static route/s to the subnets behind router, pointing to the router gateway IP.
c) Firewall->NAT, Outbound. Select "Manual Outbound NAT". Add NAT rule/s to NAT traffic from the subnets behind router, onto WAN.
d) Firewall->Rules, LAN - make sure there are pass rule/s to allow traffic with source = subnets behind router.Post details of your subnets, gateways, static routes, Outound NAT rules and Firewall LAN rules if you still have a problem.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register LoginPrivacy Policy · Cookie Policy