<![CDATA[Pfi_table_update: cannot set xx new ip addresses into table self: 22]]>Hello

I'm using the 2.2 released version on a DELL PE320
Installation worked without errors even the sofware raid worked with the internal 3x0 raid controller.
Also all BCM5720 ports are seen :)

However, I'm trying to add 120 VIPs but after adding 54 IP's I get the following error:
pfi_table_update: cannot set xx new ip addresses into table self: 22
This error shows up at the console after adding a VIP .. after adding more VIPs you only get this error/warning? during a reboot.

Can I safely ignore this error?

]]>https://forum.netgate.com/topic/78852/pfi_table_update-cannot-set-xx-new-ip-addresses-into-table-self-22RSS for NodeWed, 11 Mar 2026 01:10:20 GMTWed, 28 Jan 2015 14:32:34 GMT60<![CDATA[Reply to Pfi_table_update: cannot set xx new ip addresses into table self: 22 on Mon, 29 Jun 2015 19:27:19 GMT]]>This issue was fixed in 2.2.3.

]]>https://forum.netgate.com/post/554081https://forum.netgate.com/post/554081Mon, 29 Jun 2015 19:27:19 GMT<![CDATA[Reply to Pfi_table_update: cannot set xx new ip addresses into table self: 22 on Sat, 25 Apr 2015 20:03:34 GMT]]>Did you solve your problem?

I have a cluster of pfSense nodes. Both were version 2.1.5. I've remove the second (passive) node, rebuilt it with version 2.2.2.

Then I had the first node synchronize its configuration to the second node… And that's when I got the error.

Looking up what error code 22 is really is of no help unless you're a programmer.

http://permalink.gmane.org/gmane.comp.security.firewalls.pfsense.general/7857

Any ideas?

]]>https://forum.netgate.com/post/539803https://forum.netgate.com/post/539803Sat, 25 Apr 2015 20:03:34 GMT<![CDATA[Reply to Pfi_table_update: cannot set xx new ip addresses into table self: 22 on Thu, 02 Apr 2015 15:52:29 GMT]]>To debug this, you need to figure out what error code 22 is in function pfr_set_addrs.

]]>https://forum.netgate.com/post/533336https://forum.netgate.com/post/533336Thu, 02 Apr 2015 15:52:29 GMT<![CDATA[Reply to Pfi_table_update: cannot set xx new ip addresses into table self: 22 on Thu, 02 Apr 2015 14:04:27 GMT]]>I can see the same message on the console. Is it safe to ignore it?

]]>https://forum.netgate.com/post/533299https://forum.netgate.com/post/533299Thu, 02 Apr 2015 14:04:27 GMT