Question about NAT inside a Class A private network range
-
I'm learning, but slowly, so bear with me please.
I have a situation where I need to setup pfSense inside a 10.x.x.x network range.
The pfSense WAN interface would have a 10.x.x.x network address, and the LAN interface woudl be 192.168.10.1 and proivide IPV4 DNS via DNS resolver and DHCP service to the 192.168.10.x network range.
Is there anything special that needs to be done because the WAN interface is on a private Class A network?
Also, if this makes a difference, once IPV4 is stable and functioning I'll begin to enable IPV6.
-
No other than maybe turning off block private IPs on your wan, if your going to have devices on your wan forwarded into your lan..