Problema com Fail Over e Load Balance
-
Olá. Sou novo com pfSense, e gostaria de uma ajuda. Agradeço desde já.
Estou com um problema em um cliente, onde implementei pfSense com objetivo principal de Fail Over e Load Balance. Realizei os testes retirando cabo da WAN1 e a WAN2 assumiu normalmente. No traffic graphs eu consigo ver fluxo de rede em ambos os links (WAN1: GVT e WAN2: NET VIRTUA)
Fiz os testes tanto tirando o cabo da placa de rede quanto retirando o cabo rj11 do filtro de linha ou desligando o modem da GVT. Ressalto que a seta DOWN (vermelha) em DASHBOARD, fica vermelha apenas quando eu tiro o cabo da placa de rede ou quando desligo o modem da GVT. Não sei se isto é normal.
Problema maior: A REDE POR ALGUNS MOMENTOS FICA LENTA.
Coloquei IP FIXO em todas as máquinas e houve uma pequena melhora em alguns sites que nao pingava, pois coloquei os DNS do Google, os mesmos configurado no pfSense.
Por mais que eu veja fluxo de rede tanto na WAN1 E WAN2, vejo que todos os 5 computadores da rede está conectado na GVT (DEFAULT GATEWAY).
DNS no Setup Wizard: 8.8.8.8 (Primário) e 8.8.4.4 (Secundário)
DNS no Routing: 8.8.8.8 (Wan1 - Default Gateway) e 8.8.4.4 (WAN2)
Nas estações Windows segue a mesma configuração fixa de DNS.
Em Advanced/Miscellaneous marquei a opção Enable default gateway switching
Nas regras da LAN coloquei o seguinte na ordem:
LAN NET * * * LoadBalance
LAN NET * * * FailOverEntão, gostaria de saber se alguem pode me informar se tem algo errado nas configurações. Esta lentidão na rede está estranha…
Obrigado!!
Hello. I'm new with pfSense, and would like to help. Thanks in advance.
I have a problem on a client where pfSense implemented with the main objective of Fail Over and Load Balance. I performed the tests removing cable from WAN1 and WAN2 usually assumed. In the graphs I can see traffic network flow on both links (WAN1: GVT and WAN2: NET VIRTUA)
I did the tests either by taking the cable from the network card and removing the surge protector RJ11 cable or turning off the modem GVT. I emphasize that the arrow DOWN (red) in DASHBOARD, turns red only when I take the cable from the network card or when I unplug the modem from the GVT. I do not know if this is normal.
Biggest problem: A NETWORK FOR SOME MOMENTS IS SLOW.
IP FIXED put on all machines and there was a slight improvement in some websites that not dripping, as put Google DNS, the same set in pfSense.
As much as I see network flow both WAN1 and WAN2, I see that all 5 computers on the network is connected to the GVT (DEFAULT GATEWAY).
DNS in the Setup Wizard: 8.8.8.8 (primary) and 8.8.4.4 (Secondary)
DNS in Routing: 8.8.8.8 (WAN1 - Default Gateway) and 8.8.4.4 (WAN2)
In Windows stations follows the same fixed configuration of DNS.
Advanced / Miscellaneous marked the Enable default gateway switching
LAN in the rules put the following in order:
LAN NET * * * LoadBalance
LAN NET * * * FailOverSo, I wonder if someone can tell me if there is anything wrong in the settings. This slowness in the network is strange …
Thank you!!