Pfsense + freeradius + Microsoft Active Directory
-
Ok, then to test this I would setup an LDAP server you can see the logs in and authenticate against that first so you can see how it fails. Or doesn't.
-
Hi @stephenw10 i was thinking: there is a way to configure the Post-Auth-Type??? Since the error says "(5) login incorrect (no auth-type found: rejecting the user via Post-auth-type = reject)" is there a way to set to the post-auth a value that works with ldap?
-
Only whatever is there in the Freeradius LDAP config AFAIK.
-
Hello @stephenw10, I have some updates regarding the FreeRADIUS configuration against the LDAP server. By capturing packets and analyzing them with Wireshark, I noticed a few things:
-
The first thing is that the LDAP server insists on using EAP for authentication. When we try to authenticate using MD5 or GTC, the LDAP server rejects the packet because the security protocol is not very secure.
-
We tried enabling the "Enable LDAP for Authentication" option, and in Wireshark, we can see a packet exchange in which the user attempting to authenticate to the WiFi network is sent back to pfSense, where we have our FreeRADIUS. However, we are still encountering the error that says: "Login Incorrect (mschap: FAILED: No-NT Password. Cannot perform authentication)."
So, from what I can see, the connection to the LDAP server is working perfectly. What I don't understand is where the issue with the password lies. It could be on the FreeRADIUS side when it receives the request from the Access Point, or it might be in the LDAP server's response.
-
-
#2 there is expected. When using EAP Freeradius never has the password to use to authenticate the user. It can only pass the username to authorise it. As I understand it at least. But I'm pretty confident on that since the option notes that.
-
@stephenw10 I'm completely demotivated; I thought it was going to be simpler than it is, but it's not. The funniest thing is that, while looking at the packet capture in Wireshark, it finds the user I'm logging in with, but the mschap error "No NT-Password" keeps coming up nonetheless. I don't know what else to do. Is there anything that can be adjusted in the mschap file? I wouldn't know what, if anything. Or could something be tweaked in the LDAP attributes?
-
You're seeing that error because one side is expecting password to be sent but the other side never has the password to send.
What I suggest is to disable 'Enable LDAP for Authentication' because that cannot work with EAP types and then try to diagnose the error9s) without that. Which I expect to be an algorithm mismatch.
Steve
-
@stephenw10 should disable that option and change something in some config file? i disable and the error is the same
-
I wouldn't expect to have to make any other change there. You might try restarting Freeradius to be sure though.
-
This post is deleted!
