Wierd console loader issue on nanobsd alix
-
anything should be fine
Well, this was already excluded by your daisy-chained powered madness experiment. Some of the Prolific shit even makes this unbootable: https://forum.pfsense.org/index.php?topic=62220.0
-
true but like i said, that crash on boot issue is due to fake chips which insert rouge voltages from the rx to tx lines and this caused the bootloader to receive unknown characters causing the crash and windows filters such data where as linux etc OS dont so that crash issue is solved for me with a genuine chip now, i did the voltage tests and all seems fine now but still alix doesnt take any input during slice selection whereas going to alix bios works perfectly fine which happens before the boot loader kicks in
-
It works fine here, even with a Prolific USB serial adapter.
There was a change to the loader between 2.1.x and 2.2.x but that part would only change for new images, not upgrades.
Make certain that your BIOS serial speed is set to match the pfSense serial speed before doing anything else.
-
earlier it went dead when i upgraded and it messed some other things which was resulting in totally skipping the slice selection menu so i did a clean install and it solved that but since then, all the display etc all appears good, bios speed matches that too of the pfsense, 115200, i can goto bios and it works well, just slice selection and press enter to continue in 5s dont take any input, after that everything works normal
-
is there any way to revert to the older boot loader just to test it out and make sure its not something else affecting it.
i have tried many different chipset adapters but same result, they work fine on 2.1
-
There is no way to revert that.
-
-
Without being able to prove anything is actually broken, probably not.
In the meantime, check your serial client and try some other settings, especially important is to try changing flow control. For example, disable hardware flow control, use XON/XOFF or disable flow control entirely.
-
Works fine here too.
-
my serial client i upgraded that to latest version, played with all the possible flow control settings but still same.
if u say the alix is dead or the adapter is dead then in those cases nothing should be working at all on serial at all but then y is it that just those 2 sections input is not accepted and everywhere else it works fine, how can it not be broken when 2.1.x versions work fine with same alix and adapter?
