VLAN access failing
-
I've created an interface - VLAN 10, interface hn1.10 or something, which I assigned to LAN hn1 interface.
I've assigned ip 10.10.10.1 to it, enabled it, gave it a pass anything firewall rule. Created DHCP scope for it from 10.10.10.30 - 10.10.10.254My LAN port goes to my switch, on a "trunk" port or All because it's a Unifi switch, from there connects another device which I assign to VLAN 10 I can't get an ip address from DHCP, I can't statically assign and ping the gateway.
From the switch I can ping the gateway.I connected a Cisco 2960 trying to figure out what was going on, setup an interface VLAN 10, assigned it to a port.... called that port a trunk port with native vlan 10 and still same story.
What am I doing wrong?
-
This was because of Hyper - V
Not sure how to get Hyper V working with all this, but I set it up on bare metal and it seems to work fine