Almost there, WG is up but no access (LAN/Internet)
-
After searching I found the video from Christian. I followed exactly his step. And during the video, he also mentioned about the outbound NAT. Believe me! I thought I will bring with me to my grave for that mystery: if you do not assign an Interface to a network, you do not this Outbound NAT (I know it has nothing to do with my problem but at least I can go to the next chapter of my life knowing something). Anyway, back to the problem. I got the connection (again thanks to Christian for the Widget Plus). I can see on the PFSENSE that my laptop was connectected: RX and RX and TX ! So the connect was made... However, I am not going to blame on the Russians, but I still do not have any connection: i cannot ping 10.1.15.1 (which is the IP of the tunnel) nor 192.168.1.1 (which is my local LAN.) and the laptop (if the WG client is set to 0.0.0.0/0) lost the connection; and if the laptop is set to ALLOWEDIPS to 192.168.1.0 then I cannot ping my local LAN but my laptop can still access the Internet. What I am missing here?
1-I create a rule on the WAN
2-Allow ANY to ANY in the wireguard.
3-NAT Outbound created for 10.1.15.0/24If you help me to get connected, I am willing to send you a $50.00 gift card so you can get some beer: I am serious about it. I do have a WG on an Ubuntu server for my connection but I want to see it is working on PFSENSE... It has been a wait for me almost two years now.
JD
-
I am going to get myself a $50.00 beer. It was my mistake... On the TUNNEL settings, I need to do a /24 and /not 32 and voila.. Hasta LaVista Baby? It is all working now. I made the right decision to come back with PFSENSE. Now, more tunnels to test it.