23.01 - SquidGuard

[mokey_fraggle]

@yaw I am also running into this :(

[yaw]

@mokey_fraggle Thanks. I haven't been able to find a work around, but good to know it's not something unique with my installation.

[yaw]

@stephenw10 Any ideas? Seems like there are a few PHP errors cropping up in 23.01.

[yaw]

Opened a bug report on redmine for this.

[aniodon]

hello,
i am also affected by this issue, fortunately only on my failover node.
i didn not found any workaround so far

i'll be watching this thread

[aniodon]

@aniodon in addition : i have the same message when syncing config from my master node through xmlrpc.
-> I cannot save parameters in squidguard on my master (gateway error timeout) unless i disable the XMLRPC sync in the squidguard addon

The Gateway timeout on the master is caused by the error on the slave (cannot access offset...)

[aniodon]

I don't see much progress here...

to help diagnostic, do everyone here have HA sync enabled ?

[yaw]

@aniodon I don't use HA. So, no, it's not enabled.

[adminatalaya]

Same problem here. Will wait for a patch or instructions...

[JonathanLee]

https://redmine.pfsense.org/issues/13984

There is a Redmine open for the PHP issues and the HA issue if you want to test it out. It is running on my SG2100-MAX fine. There is two patch files one for Squid one for Squid Guard if you want to load them. Marcos' patch worked great for me.

Path Strip Count 4

[aniodon]

@jonathanlee Thanks a lot