ICMP spikes after 23.05 upgrade
-
@stephenw10 but it is only me, who is complaining about this issue with XG 7100 units? I need to get some result, as I need to upgrade our units. Can I pay to speed up resolving this issue?
-
@GeorgeCZ58 said in ICMP spikes after 23.05 upgrade:
@stephenw10 but it is only me
Perhaps the use of the Zabbix package is a discriminator here. It's not something I have used and probably the majority of pfSense users do not use it either.
If you could demonstrate the issue without an additional package it may be that others can replicate it. It would also rule-out Zabbix itself.
️ -
No there are quite a few users seeing this. I suspect there are more still who are hitting it but just not noticing because it doesn't affect most use cases significantly. I was only able to see it here by looking for it specifically.
-
-
It only affects the 7100 as far as I know at this point. Which points pretty squarely at the switch driver IMO.
-
@stephenw10 said in ICMP spikes after 23.05 upgrade:
It only affects the 7100 as far as I know at this point. Which points pretty squarely at the switch driver IMO.
And this driver was changed in 23.X release, yeah? Is there posibility to replase driver manualy?
-
It was not significantly changed. Additionally I have tested with the switch driver disabled entirely and it still shows the issue on the SFP ports so it's more subtle than just a bad driver update.
-
@stephenw10 said in ICMP spikes after 23.05 upgrade:
It was not significantly changed. Additionally I have tested with the switch driver disabled entirely and it still shows the issue on the SFP ports so it's more subtle than just a bad driver update.
Yes, it is presented on all types of ports. Usually I have WAN on expansion card or ETH1, LAN on SFP+ or ETH2, depend of current usage of XG7100.
-
@stephenw10 can you please make test on pFsense Plus 24 version, if issue persist here?
In the end of the year I have possibility to upgrade our devices, but seems, like issue is still not resolved. So my question again - are there any possibilities, how to support resolving of this issue?
-
Just upgraded another XG7100 remotely in different country. It was on 22.05, now 23.09.1
Latency is here :-/ . I need to resove that.
-
Ater upgrade to 24.03 the issue persist. I thought, that if we will use Netgate generic HW, we will not be in troubles, unfortunately it seems, that nobody care. I do not have this issue on homelabs with non Netgate HW. All 7100 are affected by this issue.
