Subnet 2 and DMZ have no Internet access.
-
Hoba– Thank you for your help.
Last night I hooked up my Asterisk box (Asterisk@Home distro). It has an ip address of 192.168.3.2. I cannot access it from my workstation that is on the .1.x subnet. I thought that the firewall rules you gave me would allow me from any subnet to access any computer on the .2.x or the .3.x subnets. How do I go about rectifying this problem? Asterisk@Home is configured through AMP, Asterisk Management Portal, a webgui. I was trying to access the box through that and ssh.Thanks
-
Make sure you are running an image from: http://www.pfsense.com/~sullrich/1.0-BETA1-TESTING-SNAPSHOT-1-24-06/
-
can i use the auto update feature to intstall that?
i installed from the livecd that i downloaded from the download area. i installed pfsense over this past weekend.
where is the version number?
-
manual update.
as it has been mentioned atleast 100 times in this forum alone, auto update is being worked on.
-
do i want the 27 meg file or the 2 meg file?
I'm new to pfsense and i havent fully read through the forums.Thanks for the help.
-
2 mb is for embedded versions, 29 mb is for harddisk installs.
-
where is the channel log located? i looked under the blogs and tutorials and the faq but never seem to have found it.
I am still having my problem of being unable to access AMP from my .1.x subnet. the asterisk box is on the .3.x subnet
Any ideas?
-
check firewall logs if something is blocked. if you see blocks your rules are not set up correctly. if you don't see blocks check if all your machines have the pfsense as gateway ip at their local interface. You might as well test that with traceroute from both ends to the other end to see where it stops. you should see only one hop.
-
ok
if i am on a copmuter in the 192.168.1.x subnet i can successfully ping the interfaces for the .2.x(lan 2) and the .3.x(DMZ) subnets. i cannot ping any IP addresses after .2.1 or .3.1.
i am at a computer of IP address of .2.2 or higher or .3.2 or higher i can only successfully ping the .2.1 or .3.1 address but NOT the .1.1 address.
i also CANNOT ping a .3.x from .2.x and the inverse of that is true as well.
The .2.1 subnet has internet access.
When I try to ping any address other than what is within(outside) the subnet i am recieve this message: Destination Host UnreachableI ran traceroute but I dont exactly know what response i am looking for. What response do i want? The route should not be too many hops as its just a couple of NICs.
Thanks
-
do you have setup the firewall rulles for ping ?
if you put on the lan tab the opt1 tab and the opt2 tab this rule
icpm * * * * *then they can ping lan network opt1 netwerk opt2 network and the internet