Captive portal stopped working after adding new interfaces
-
I had pfsense rc1 running just fine on a box with 2 interfaces and captive portal worked like a champ ( no auth). I just want the splash page to indicate an 'acceptable usage' policy. After adding the two interfaces and configuring one of them for out-of-band management and the other will be used for carp when I have time to build a 2nd pfsense box the captive portal option no longer works. I can get out to the web just fine when it is disabled. clients receive dhcp from another server.
Thanks,
Eric
-
Also, under status:Captive portal, the mac addresses no longer appear. I enabled the 4th interface even though I am not ready to connect it yet and will try a reboot as well
That did not work. I will go to the console and start from scratch.
-
that did not work either. I will disable the two added interfaces in bios (the orginal values) and start again from scratch. It is a shame as I wanted to have out-of-band management & failover running.
-
Also, under status:Captive portal, the mac addresses no longer appear.
This sounds like a broken install to me. I suggest reinstalling the latest snapshot from scratch and setting it up again. It should work.
-
I tried to push it up via firmware upgrade to save some time, but no go. I will wipe the box & reload. This time I will enable the other two nics in bios prior to the install