Extend Network to other factory
-
I would go with AP at one end and infrastructure at the other end.
-
Hi,
I am also trying to setup a similar configuration, but my question is how do I get the one pfsense1 wireless to connect to pfsense2's wireless.
I have pfsense2 as a wireless AP, but how do I setup pfsense1 to conenct to that AP?
Thanks
Tonino -
The second pfSense has to be set to mode "infrastructure" with the same channels/ssid/encryption/… .
-
great - thanks. I got it working.
:)
-
For future reference: http://wiki.pfsense.com/wikka.php?wakka=Wireless
-
Hi all,
I have tried this setup. I have set it all up in one room at the moment with 2 computers. I have set 1 as an AP and the other as infrastructure. However for some reason when i go to status/wireless it wont show the AP but it will show our AP for our internet connection. If i scan for AP's using my laptop it will show both the Internet AP and the PF AP. They are both on different channels.
Any help please?Beau
-
Ok,
I can see the Infrastructure PF box from the PF AP and it even show the wireless ip of the INF PF in the ARP tables, i have created the rules any,any,any for both the lan and the wireless on both box and i cannot ping the other box from the AP.
Beau -
Make sure you have all needed routes in place and you did shut down natting where needed. You also need to uncheck interfaces>wan "block private IP Ranges".
-
Hi Hoba,
Sorry to be a pain again (i am new to this) i still cannot get this to work for some reason, i cannot even ping between the 2 pfsense units. With the rules do i set them in the NAT page or in Firewall/Rules page? And with the static routes what would the Gateway be?Thanks,
Beau
-
the simpler way is to buy 2 access points that are WDS or bridges capable (like buffalo WHR-HP-G54), once wireless link is configured by wds for example, you just need to connect them to each part of your network
Chady